Butt pack v.2 SPLAV

A classic butt pack. Compared to the old model, the pouch became lighter in weight and simpler in design, and got the right rounded shape

• Mount: UniClick third generation system. Four built-in clips. For attaching to the classical PALS / MOLLE system, six cells in width and two to four horizontal rows of cells in height
• The corners of the bottom are rounded for protection against rubbing
• Internal flat vertical pockets on the side walls, with the entrance from above, from the fabric Oxford 210d. They are convenient for placing small bottles of water, RSP / ROP / RDG, mags, etc.
• The tube is made of Oxford 210d fabric with a paracord retractor and Duraflex® retainer. The exit point of the cord from the edge of the tube is reinforced with braid and several barbs
• The valve has a complex rounded shape with side walls, gently covering the top of the tube at any height adjustment
• The front of the valve is sewn with a Velcro-loop for fixing the chevrons, the size of the Velcro is 12 × 5 cm
• At the top of the valve there are four hinges of the strap for attaching two fastening belts (to be purchased separately, for example, a set of fastening lines with Duraflex®)
• The valve is fastened to two Duraflex® fastexes with the possibility of adjustment. The slings of the main fastex continue down the bottom to the back wall, forming a power frame. Also, this makes it possible to very tighten the volume of the pouch if necessary. To prevent the slings from slipping, they pass through the horizontal hinges attached to the front wall of the pouch. The excess ends of the lines fold and hide under the rings of rubber bands
• The slings of the valve at the bottom of the pouch are threaded through the Duraflex® single-slit buckles and form integral straps. The length of the sling is sufficient to fix small foam mats, grenade launchers, etc. on the bottom. subjects
• Behind the back there are two Duraflex® half rings for suspension to the straps of the RPS. The mutual arrangement of the rings is optimal for compatibility with Alloy straps - Nemesis-5 and Universal lightweight v.3. It is strongly recommended to hang the bag to the rear straps of the straps if possible, while the belt / belt of the RPM should be fastened approximately in the middle of the bag, not to its upper part. So the bag will hang less and interfere with the seat
• The outer side surface is sheathed by PALS cells for hanging additional pouches (for example, a utility pouch with a zipper of 3 × 3). 3 cells in width, 4 rows in height on each side
• All sections of fabric and sling are hidden under the seams or edged for reliability
• At the bottom there are two eyelets for draining water. The location of their installation is reinforced with pieces of slings for protection against tearing

CHARACTERISTICS:

• Slings: 100% nylon
• Threads: Liberty® (Netherlands) filament nylon bonded
• Material: Cordura® 500d (100% nylon), Oxford 210d (100% nylon)
• Fittings: Duraflex®
• Velcro: Alfatex® (Belgium)
• Cord: Paracord 550, 100% nylon
• Size: 31 × 24 × 12.5 cm (roughly indicated average height)
• Weight: 392 g